Port Link-Aggregation Group; Reset Counters Interface - HP 3100 v2 Series Command Reference Manual

The minimum numbers of Selected ports for the local and peer aggregation groups must be
consistent.
Examples
# Configure the minimum number of Selected ports as 3 in the aggregation group corresponding to
Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port minimum 3

port link-aggregation group

Syntax
port link-aggregation group number
undo port link-aggregation group
View
Ethernet interface view
Default level
2: System level
Parameters
number: Specifies the number of the aggregate interface corresponding to an aggregation group.
•
On the HPE 3100 v2 EI, the value range is 1 to 13.
•
On the HPE 3100 v2 SI, the value range is 1 to 9.
Description
Use port link-aggregation group to assign the Ethernet interface to the specified aggregation
group.
Use undo port link-aggregation group to remove the Ethernet interface from the aggregation
group to which it belongs.
An Ethernet interface can belong to only one aggregation group.
Examples
# Assign Layer 2 Ethernet interface Ethernet 1/0/1 to Layer 2 aggregation group 1.
<Sysname> system-view
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] port link-aggregation group 1

reset counters interface

Syntax
reset counters interface [ bridge-aggregation [ interface-number ] ]
View
User view
Default level
2: System level
79