Avaya Definity SI Maintenance Manual page 366

Maintenance Commands and Trouble-Clearing Aids
CPE Alarm
Activation Level
Packet Bus
Activated
Customer Access
to INADS Port
Repeat Dial
Interval (MMS)
8-116 Issue 4 May 2002
Indicates the minimum level (Major, Minor or Warning) at which
the Customer-Provided Equipment (CPE) alarm is activated. If
the level is none , the CPE does is not activated for any alarm.
(none)
NOTE:
The CPE alarm is always activated when the
switch goes into Emergency Transfer, regardless
of the CPE Alarm Activation Level setting.
Enables the system Packet Bus.
If this field reads yes , then maintenance software assumes
that there is a Packet Control circuit pack installed in the
system. The packet endpoints (for example, ASAI, and/or BRI)
may be administered, and maintenance testing runs on both
the Packet Control circuit pack and on the Packet Bus (This
field should read yes after a packet control circuit pack is
installed.). If a Packet Control circuit pack is not installed in the
system, then a major alarm is raised against the PKT-CTRL
MO.
This field can only be changed from
packet endpoints administered, thus ensuring that there can be
no packet endpoints administered if the packet bus is not
activated.
This field should be set to yes after a Packet Control circuit
pack is installed.
If a Packet Control circuit pack is not installed, then this field
should be set to "no'' (the only exception is when setting up
translations for a system for which not all of the required
hardware is available). (n)
Provides the capability to prohibit access to system
administration and maintenance interface, via the INADS port
when using customer login ID's. This field can only be activated
by Avaya services through system-parameters maintenance
administration. (n)
Indicates the number of minutes that the system must wait
before attempting another call origination to an OSS. This timer
is triggered by the lack of a far-end acknowledgment. (7)
to if there are no
yes no
555-233-123