Download Update-File - Avaya Definity SI Maintenance Manual

Maintenance Commands and Trouble-Clearing Aids

download update-file

The update file is transferred to the switch asynchronously from either an INADS
host or a personal computer (PC) using the XMODEM protocol.
Remote download
Remote users can dial into the switch by either using the "call" command (from an
INADS host) or by dialing the switch directly with a modem. Once the connection
has been established, the user logs into the switch as a remote system access
terminal (SAT) using the inads login.
NOTE:
Only the INADS and INIT logins have the necessary permission to send an
update file to the switch.
1. Type the download update-file command and press
wait... displays on the screen.
After completing some initialization, Please start file
transmission now... displays.
2. Start an XMODEM session on the remote end and send the update file.
a. INADS host: enter ~dload <file_name> to start the file
b. PC: follow the instructions in the emulator's manual for invoking an
Each block is written to tape or flash card as it is received by the switch. The link
level of XMODEM provide error detection and retransmission. Additional
protection is provided within the application level. After the entire file has been
written to tape or flash card, it is read back and each update file block is validated,
and the file checksum is also checked. If the file appears to be sound, the status
word in the header block is changed to indicate that it is a valid update file.
There may be a delay (up to 5 minutes on a duplex system) between the end of
the file transmission and command completion. This delay is caused by the patch
application of any immediate sub-patches and, if on a duplex system, the
automatic copy of the update file to the standby SPE, which takes place after
receiving a valid update file.
In a High or Critical Reliability System, the connection to the INADS host
computer can be dropped by the INADS side, but the process of copying the
patch file to the standby processor continues. The standby is placed in
maintenance mode and a call placed between active and standby SPE over the
data channels. The file is transmitted in the same way for both tape and flash card
systems. The same checks are made on the receiving side as were made during
and after the original download. If no errors are found, the file is marked valid.
8-126 Issue 4 May 2002
transmission.
XMODEM session to send the update file.
. Please
ENTER
555-233-123