Memory; Mis (Management Information System) - Avaya Definity SI Maintenance Manual

MEMORY

MEMORY
MO Name (in
Alarm Log)
MEMORY
Refer to MEM-BD (Memory Circuit Pack) for circuit pack level errors.
MIS (Management Information
System)
MO Name (in
Alarm Log
MIS
Management Information System (MIS)/Call Management System (CMS) MO is
used for administering MIS translations, such as trunks and stations. There are no
hardware failures associated with this MO.
To diagnose MIS link hardware errors and alarms, see PI-LINK (Processor
Interface Link) and PI-SCI (System Communication Interface) maintenance
information.
MIS/CMS is an adjunct processor that collects ACD data sent from the system. To
change MIS translations, enter busyout mis at the terminal. When the MIS is
busied out, the system stops sending ACD data to the MIS, and a Warning alarm
is raised. When finished, enter release mis. This clears the Warning alarm and
allows the switch to send ACD data to the MIS.
Error Log Entries and Test to Clear Values
Management Information System Error Log Entries
Error Type Aux Data
1
0 0
18(a) 0
1 Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence.
Note:
a. When busyout MIS is issued, no data is sent to the MIS/CMS. To allow
data to be sent to MIS/CMS, issue release mis from the terminal.
555-233-123
Alarm
Level Initial Command to Run
MAJOR test memory a/b l c
Alarm Initial Command
Level to Run
WRN release mis
Associated Test Alarm Level
Any Any
busyout mis WARNING
Full Name of MO
memory
Full Name of MO
Management Information System
On/Off
Board Test to Clear Value
Any release mis
ON release mis
Issue 4 May 2002 10-1095