Before Start; Get Help - D-Link DI-1750 Reference Manual

1.3 Before Start

Please confirm the following steps before power on the router for configuration:
(1) Set up Router's hardware according to the requirement of User Manual
(2)
Configure the PC terminal emulation program
(3) For Internet Protocol (IP), decide:
· Layout of IP addresses
· Which WAN (Wide Area Network) protocols (egg. Frame Relay、 HDLC、 X.25) are to be used on
each port.

1.4 Get Help

ls command and its -1 option can help to input the commands:
♦ Type in 1s command to display the list of currently available commands
[DEFAULT@Router /]#ls
♦ Type in ls – l command to display the list of currently available commands and the brief
introduction
[DEFAULT@Router /]#ls -l
♦ Press Up direction key to display the formerly input commands. To display more commands please
continue to press the Up key.
1.5 Command Directory
The Router user interface includes various directories, each of them enable you to configure different
components on the Router. The currently available command relies on the location of your command
directory. Type in the 1s command to display the available command list under each command
directory. The following table lists the frequently used commands:
Command Directory
System
Directory
User Directory
Management Directory
Global Configuration
Directory
Each command directory has a limit to use the subset of commands. If you have a problem when
inputting the command, please check the prompt and input 1s command to obtain available commands
list.
Please notify the new command directory that displayed by the change of interface prompt in the
following example：
[DEFAULT@Router/]# cd enable
Password: <enter password>
[DEFAULT@Router/enable/]# cd config
[DEFAULT@Router/config/]# cd ..
[DEFAULT@Router/enable/]# cd ..
[DEFAULT@Router/]#
Entry Method
Monitor Power on the device and
input ""Ctrl+Break
Log in
Input "cd
command under
User Directory
Input "cd
command under
Management Directory
Model Name
Interface Promote
monitor#
[DEFAULT@Route
r/]#
enable" [DEFAULT@Route
the r#enable/]#
config" [DEFAULT@Route
the r/config/]#
- 2 -
Quit Method
By quit command
By exit or quit command
By cd.. command
Use cd.. command to return to
the Management Directory