D-Link DI-1750 Reference Manual page 176

Please Input the code of command to be excute(0-1): 1
Input 1，select pool option，prompt is as below:
(00)WORD Pool name for global addresses
Please Input the code of command to be excute(0-0): 0
Input 0，select WORD option，prompt is as below:
Please input a string:
(00)overload Overload an address translation
(01)<cr>
Please Input the code of command to be excute(0-1): 1
Input 1, it will establish dynamic source address translation.
Step 4：
Input interface command, prompt is as below:
(00)FastEthernet FastEthernet interface
(01)Ethernet Ethernet interface
(02)Serial Serial interface
......
Please Input the code of command to be excute(0-10):
Specify inside interface type and number.
Step 5：
Select option 18 in the prompt, it will list all arguments:
(00)access-group
......
(09)nat NAT interface commands
......
Please Input the code of command to be excute(0-18): 9
Input 9, select nat option, prompt is as below:
(00)inside Inside interface for address translation
(01)outside Outside interface for address translation
Please Input the code of command to be excute(0-1): 0
Input 0, select inside option, it will sign the interface to be connected to inside network.
Step 6：
Input interface command in global configure directory, prompt is as below:
(00)FastEthernet FastEthernet interface
(01)Ethernet Ethernet interface
(02)Serial Serial interface
......
Please Input the code of command to be excute(0-10):
Specify outside interface type and number.
Step 7：
Select 18 option in the prompt, it will list all arguments:
(00)access-group
......
(09)nat NAT interface commands
......
Please Input the code of command to be excute(0-18): 9
Input 9,select nat option, prompt is as below:
(00)inside Inside interface for address translation
(01)outside Outside interface for address translation
Please Input the code of command to be excute(0-1): 1
Input 1, select outside option, it will sign the interface to be connected to outside network.
Notes:
The access list must permit only those addresses that are to be translated. (Remember that there is an implicit "deny all" at
the end of each access list.) An access list that is too permissive can lead to unpredictable results.
Model Name
Specify access control for packets
Specify access control for packets
- 174 -