D-Link DI-1750 Reference Manual page 266

input 10，Select route-reflector-client option .
An autonomous system can have multiple route reflectors. A route reflector treats other route reflectors
just like other IBGP speakers.
Usually a cluster of clients will have a single route reflector. In that case, the cluster is identified by the
router ID of the route reflector. To increase redundancy and avoid a single point of failure, a cluster
might have more than one route reflector. In this case, all route reflectors in the cluster must be
configured with the 4-byte cluster ID so that a route reflector can recognize updates from route
reflectors in the same cluster. All the route reflectors serving a cluster should be fully meshed and all of
them should have identical sets of client and nonclient peers.
If the cluster has more than one route reflector, configure the cluster ID by performing the following task
in router configuration mode:
bgp cluster-id cluster-id
In the prompt Select 1 option ，prompt is as below:
(00)always-compare-med
......
(03)cluster-id
......
Please Input the code of command to be excute(0-8): 3
input 3，Select cluster-id option ，prompt is as below:
(00)A.B.C.D
(01)<1-4294967295>
Please Input the code of command to be excute(0-1):
Select parameter ，cluster-id value .
See the "BGP route reflecter configuration example" for an example of route reflector configuration.
6.12.20 Disable Peer
Use the following BPG configuration command to disable BGP neighbor:
neighbor {ip-address | peer-group-name} shutdown
In the prompt Select 12 option ，prompt is as below:
(00)A.B.C.D
Please Input the code of command to be excute(0-0): 0
input 0，Select A.B.C.D option ，then prompt 为：
Please input a IP Address:
input IP ，prompt is as below:
(00)default-originate
......
(13)shutdown
......
Please Input the code of command to be excute(0-17): 13
input 13,Select shutdown option .
Use the following BPG configuration command to enable the the neighbor that former disabled:
neighbor (undo) {ip-address | peer-group-name}
shutdown
In the prompt Select 12 option ，prompt is as below:
Command
Always compare MED
Route reflector cluster identifier
IP address
ID number
Command
IP address of neighbor
Permit announcement of default route to neighbor
Shutdown neighbor
Command
Model Name
Configure cluster ID.
Disable BGP neighbor.
Enable BGP neighbor.
- 264 -
Purpose
Purpose
Purpose