D-Link DI-1750 Reference Manual page 215

6.10.4 Configure the Percentage of Link Bandwidth Used
By default, BEIGRP packets consume a maximum of 50 percent of the link bandwidth. You might want
to change that value if a different level of link utilization is required, or if the configured bandwidth does
not match the actual link bandwidth and you want to adjust actual bandwidth of BEIGRP by command.
To configure the percentage of bandwidth, use the following command in interface command of global
configure directory:
ip bepbandwidth-percent percent
[DEFAULT@Router /config/]#interface
Key Word:
U(undo) D(default) Q(quit)
(00)FastEthernet
(01)Ethernet
(02)Serial
(03)Async
(04)Null
(05)Loopback
(06)Tunnel
(07)Dialer
08)Multilink
(09)Virtual-template Virtual template interface
(10)Virtual-tunnel
Please Input the code of command to be excute(0-10): 0
Note:
Here input interface type ，FastEthernet is only an example..
Please input a interface name:f0/0
Note:
here input interface name，f0/0 is only an example..
Will you excute it? (Y/N):y
Key Word:
Q(quit)
.....
(18)history look up history
(19)interface interface configuration
(20)ip IP configuration commands
(21)keepalive Enable keepalive
.....
Please Input the code of command to be excute(0-35):20 （Select IPCommand）
Key Word:
U(undo) D(default) Q(quit)
(00)access-group
(01)address
(02)beigrp
(03)directed-broadcast Enable forwarding of directed broadcasts
(04)fast-switch
.......
(18)unnumbered
(19)unreachables
Please Input the code of command to be excute(0-19): 2
input 2，Select beigrp option ：
Key Word:
Command
FastEthernet interface
Ethernet interface
Serial interface
Asynchronous interface
Null interface
Loopback interface
Tunnel interface
Dialer interface
Multilink-group interface
Virtual tunnel interface
Specify access control for packets
IP address
Enhanced Interior Gateway Routing Protocol
Fast-Switch interface commands
Enable IP processing without an explicit address
Enable sending ICMP Unreachable messages
Model Name
Function
Configures the maximun percentage of bandwidth that
may be used by BEIGRP on an interface.
- 213 -