D-Link DI-1750 Reference Manual page 491

User can use the following command in management mode:
clear dlsw circuit [circuit-id]
rm dlsw reachability
14.2 Configuring LLC2
LLC2 (IEEE 802.2) type 2 provides connection-oriented service and is widely used in LAN
environments, particularly among IBM communication systems connected by Token Ring. Our router
supports LLC2 connections over Ethernet.
LLC2 command provides the function which support the implementation of DLSw protocol.
14.2.1 Configure the DLSw idle-time
llc2 idle-time seconds
llc2 (undo) idle-time
Note:
During the idle time, there is no I frame exchanged, sending the RR frame to the remote frequently to ask the remote local be
ready to receive the data; Set smaller value can notify the remote in time, while too small may arose much more RR frame
sent by network.
Select the IIC2 commands from the interface commands of the global configuration list, all IIC2
selection as fellow:
Key Word:
U(undo) D(default) Q(quit)
(00)ack-max the Max I-frames received before sent acknowledgment
(01)ack-delay-time the Max time to delay the acknowledgment of I-frames
(02)holdqueue the max queue lenght
(03)idle-time the timer for idle
(04)local-window the local window size
(05)n2 the retrying counts
(06)t1-time the timer of receiving an acknowledgment
(07)tbusy-time the timer of re-querying remote busy
(08)tpf-time the timer of receive a response PDU(F=1)
(09)trej-time the timer of receiving a reply to a sent REJ PDU
Please Input the code of command to be excute(0-9): 3
Input 3，select <idle-time> item
Key Word:
Q(quit)
(00)<1-60> seconds -- the maximum time for idle
Please Input the code of command to be excute(0-0):0
Please input a digital number:12
Input 12，It means sending the RR frame every 12s
Will you excute it? (Y/N):y
Model Name
Command
Command
- 489 -
Function
Clear DLSw circuit
Clear DLSw statistics
Function
This command is used to control the frequency of polls
during periods of idle time (no traffic).
Number of seconds (s) that can pass with no traffic
before the LLC2 station sends a Receiver Ready frame.
The minimum is 1 s. The maximum is 60s,default value is
10 s.
Return to the default value