D-Link DI-1750 Reference Manual page 44

Please Input the code of command to be excute(0-0): 0
Input 0，it will prompt:
Please input a string:
Input the Hostname or IP address，it will prompt:
(00)WORD
Please Input the code of command to be excute(0-0): 0
Input 0, choose the item "word", it will prompt:
Please input a string:
Input string, it will prompt:
(00)authentication
(01)configure
(02)snmp
(03)<cr>
Please Input the code of command to be excute(0-3):
Choose the aimed trap-type.
The SNMP agent will automatic boot after switch on D-Link Router and then activate all types of trap.
Use the command snmp-server host to assign the type of traps and the receiving host.
Some traps must be control by other commands. For example, if the SNMP link trap needs to be sent
while open or close the interface, so that the command snmp trap link-status is used for activate link
trap in the mode of interface configuring. The interface configuring command no snmp trap link-stat is
used for close these traps.
The host must be configured with the command snmp-server host for receiving traps.
4.1.8 Change the running parameter of trap
As option, the command is use for assign the source interface to generate traps, and then assign each
host with the queue length of message (data packet) or value of retransmission interval. Use following
optional command in the mode of global configuration to change the running parameter of trap:
Command
snmp-server
interface
snmp-server
length
snmp-server
seconds
Take the first command for example, input the command "snmp-server", it will prompt:
(00)community
......
(06)trap-source
......
Please Input the code of command to be excute(0-8): 6
Input 6, choose the item "trap-source", it will prompt:
(00)FastEthernet
(01)Ethernet
(02)Serial
(03)Async
(04)Null
Please Input the code of command to be excute(0-4):
Choose and input the type, slot and port number of the interface.
Model Name
SNMP community string
Allow authentication failure traps
Allow SNMP-configure traps
Allow SNMP-type traps
Assign the source interface (include IP address) for generating
trap-source
of trap message. This command is also sets resource IP
address for message.
Create message queue length for each trap host.
queue-length
Define the frequency of the retransmitting trap message that in
trap-timeout
the retransmitting queue.
Enable SNMP; set community string and access privs
Assign an interface for the source address of all traps
FastEthernet interface
Ethernet interface
Serial interface
Asynchronous interface
Null interface
Function
- 42 -