D-Link DI-1750 Reference Manual page 249

♦ Configure BGP Interactions with IGPs
♦ Configuring BGP Weights
♦ Configure BGP Route Filtering by Neighbor
♦ Configure BGP Route Filtering base on Port
♦ Disable Next-Hop Processing on BGP Updates
6.12.7 Enable BGP Routing Select ion
To enable BGP routing select ion, using the following commands beginning in global configuration
mode:
router bgp autonomous-system
network
route-map-name]
Step1：
input routerCommand，prompt is as below:
(00)beigrp
(01)bgp
(02)ospf
(03)rip Enable Routing Information Protocol(RIP)
Please Input the code of command to be excute(0-3): 1
input 1，Select bgp option ，prompt is as below:
(00)<1-65535>
Please Input the code of command to be excute(0-0): 0
input 0，then prompt is as below:
Please input a digital number:Please input a string:
input autonomous-system value .
Step2：
In the prompt Select 13 option ，prompt is as below:
(00)A.B.C.D/n
Please Input the code of command to be excute(0-0): 0
input 0，prompt is as below:
Please input a string:
input network-number/masklen value ，prompt is as below:
(00)backdoor
(01)route-map
(02)<cr>
Please Input the code of command to be excute(0-2):
Select detailed parameter .
Note:
For exterior protocols, a reference to an IP network from the network router configuration command controls only which
networks are advertised. This behavior is in contrast to IGP, such as IGRP, which also use the network command to
determine where to send updates.
Note:
The network command network is used to inject IGP routes into the BGP table. The resources of the router, such as
configured NVRAM or RAM, determine the upper limit of the number of network commands you can use. Alternatively, you
could use the redistribute router configuration command redistribute to achieve the same result.
Command
network-number/masklen
Enable BEIGRP (compatible with eigrp)
Enable Border Gateway Protocol (BGP)
Enable Open Shortest Path First (OSPF)
Local anonymous system number
IP Prefix
Specify a BGP backdoor route
Route map to modify the attribute
Model Name
Enable a BGP routing process, which
places you in router configuration mode.
[route-map Flag a network as local to this autonomous
system and enter it to the BGP table.
- 247 -
Purpose