D-Link DI-1750 Reference Manual page 122

Will you excute it? (Y/N):y
Key Word:
U(undo)
......
(10)dialer
(11)dialer-group
Please Input the code of command to be excute(0-32):10
Key Word:
U(undo) D(default)
......
(05)idle-timeout
(06)load-threshold
......
Please Input the code of command to be excute(0-11):5
(00)<0-2147483>
Please Input the code of command to be excute(0-0):0
Please input a digital number:Please input a string:300（input idle timeout value）
Will you excute it? (Y/N):y
Key Word:
U(undo)D(default)Q(quit)
......
(10)dialer
(11)dialer-group
Please Input the code of command to be excute(0-32):10
Key Word:
U(undo)D(default)Q(quit)
......
（09）rotary-group
（10）string
Please Input the code of command to be excute(0-11):11
Key Word:
U(undo)D(default)Q(quit)
......
（00）DialerDialer interface
Please Input the code of command to be excute(0-0): 0
Please input a digital number:Please input a string:d1（input Dialer interface）
Will you excute it? (Y/N):y
Repeat Steps 1 through 6 for configure other BRI interfaces.
Note:
To configure set-dialer rotary-group interface, the PPP configuration will automatic synchronize with corresponding dialer
interface
5.7.13 Configure Multilink PPP on DSL
To configure Mutlilink PPP on multiple DSL interfaces, you must establish a multilink group interface
with default configuration that is of Multilink PPP. Then independently configure each DSL interface and
associate into the same multilink group.
1. Configuration of establishing multilink group interface as below:
interface multilink group-number
ip address ip-address mask
ppp
[null|local|ip|ieee8021|ppp|psnd]
D(default)
Dial-on-demand routing (DDR) commands
Assign interface to dialer-list......
Q(quit)
Set idle time before disconnecting line
Specify threshold for placing additional calls
Idle timeout in seconds
Dial-on-demand routing (DDR) commands
Assign interface to dialer-list......
Add this interface to a dialer rotary group
Set default telephone number......
Command
lcp enddisc-type
Model Name
Q(quit)
Purpose
Define multilink group interface
Specify appropriate IP address.
(optional) designate enddisc type
- 120 -