D-Link DI-1750 Reference Manual page 63

U(undo) D(default)
......
(04)local-dlci
(05)map
......
Please Input the code of command to be excute(0-10): 5
Key Word:
Q(quit)
(00)A.B.C.D
Please Input the code of command to be excute(0-0): 0
Please input a IP Address:192.168.0.1 （input ip address）
Key Word:
Q(quit)
(00)pvc
Please Input the code of command to be excute(0-0): 0
Key Word:
Q(quit)
(00)<16-1007>
Please Input the code of command to be excute(0-0): 0
Please input a digital number:Please input a string:100 （input pvc number）
Key Word:
Q(quit)
(00)broadcast
(01)<cr>
Please Input the code of command to be excute(0-1): 0
Key Word:
Q(quit)
(00)<cr>
Please Input the code of command to be excute(0-0): 0
Will you excute it? (Y/N):y
You can be greatly simplifying the configuration for the Open Shortest Path First (OSPF) protocol by
adding the optional broadcast keyword when doing this task.
See the "Static Frame Relay Configuration Example" at the end of this chapter for more information
about examples of static Frame Relay configuration.
5.3.3 Straight configure the LMI
The Frame Relay software supports the industry-accepted standards of the Local Management
Interface (LMI). To configure the LMI, complete the steps in the following sections. The step in the first
is required.
5.3.4 Set the LMI Type
If the router is attached to a public data network (PDN), the LMI type must match the type used on the
public network. Otherwise, you can select an LMI type to suit the needs of your private Frame Relay
network.
You can set following three types of LMIs on router: ANSI T1.617 Annex D, Group of Four Rev. #1, and
ITU-T Q.933 Annex A. Of couse, the LMI can be setted as none. To do so, perform the following
command in interface configuration mode:
Command
Frame-relay (undo) lmi-type
{ansi | bcisco | q933a }
exit
write
Key Word:
Model Name
Q(quit)
Set local DLCI parameters
Set map table for Framerelay
IP address
PVC type
DLCI number
Broadcasts should be forwarded to this address
Set the LMI type, command no is use for restore the default
configuration of LMI type.
Quit the configuration mode.
Write the configuration.
- 61 -
Purpose