D-Link DI-1750 Reference Manual page 506

3. Half-Duplex Configuration Example
In the following example, an SDLC interface has been configured for half-duplex mode:
♦ config-encap sdlc
♦ sdlc simultaneous half-duplex
sdlc Configuration Example 1-1
llc2
HOST A
This example describes an SDLC configuration which implements the support for DLSW+.In the
example, the MAC address of HOST A is 4000.1111.0001
Router A, as a remote secondary station, is configured as follows:
config-interface fastethernet 0
bridge-group 10
Router B as remote secondary station: primary station of c1 and c2, c1 and c2 reserved for DLSw+ and
can not be used by any other data link user. c1 is PU2.0, c2 is PU2.1. SDLC configuration as below:
config-interface serial 0
config-encap sdlc
config-sdlc vmac4000.1111.0001
config-sdlc address c1
config-sdlc xid c1 01712345(configuringXID, as PU2.0)
config-sdlc partner 4000.1234.00C1 c1
config-sdlc address c2(default configuration isPU2.1)
config-sdlc partner 4000.1234.00C2 c2
config-sdlc role primary
4. sdlc Configuration Example
sdlc
HOST A
This example describes an SDLC configuration which implement the support for DLSW+.
Router A, as a local secondary station, SDLC configured as follows:
config-interface serial 0
config-encap sdlc
config-sdlc vmac4000.1234.0000
config-sdlc address c1
config-sdlc xid c1 01712345(configured XID as PU2.0)
Model Name
dlsw
Router A
dlsw
Router A
- 504 -
Router B
sdlc
Router B
C1
sdlc
C2
C1
C2