D-Link DI-1750 Reference Manual page 400

Please Input the code of command to be excute(0-0): 0
Input 0 and select <0-32767>option:
Please input a digital number:15
Note： Input the upper limit of 0－32767queue, 15 is only for example.
Key Word:
Q(quit)
(00)<0-32767> Middle limit
Please Input the code of command to be excute(0-0): 0
Input 0 and select <0-32767>option:
Please input a digital number:50
Note：Input the middle value of 0－32767queue here, 50 is only for example.
Key Word:
Q(quit)
(00)<0-32767> Normal limit
Please Input the code of command to be excute(0-0): 0
Input 0 and select <0-32767>option:
Please input a digital number:70
Note：Input a common value of 0－32767queue here, 70 is only for example.
Key Word:
Q(quit)
(00)<0-32767> Low limit
Please Input the code of command to be excute(0-0): 0
Input 0，select <0-32767> option：
Please input a digital number:100
Note： Input a lower value of the upper limit of 0－32767queue, 100 is only for example.
Will you excute it? (Y/N):y
Example
Specifies the maximum number of packets allowed in each of the priority queues 10 50 70 100
prority-list 4 queue-limit 15 50 70 100
To specify which queue to place a packet in, use the following commands in global configuration mode:
Command
priority-list list-number
protocol-type {high | medium | normal
| low} [keyword key-value]
priority-list
config-interface
interface-number {high | medium |
normal | low}
priority-list
queue-number
priority-list list-number
protocol-type {high | medium | normal |
low} [keyword key-value]
To configure the classification of a PQ list by the protocol type, you can input: priority-list:in a global
configuration directory:
[DEFAULT@Router /config/]#priority-list
Key Word:
U(undo) D(default) Q(quit)
(00)<1-16> priority list number
Model Name
Establishes queueing priorities based on the protocol
protocol
type.
Establishes queueing priorities for packets entering
list-number
from a given interface.
interface-type
Assigns a priority queue for those packets that do not
list-number default
match any other rule in the priority list, the default value
is normal.
protocol
Establish PQ by the protocol type
Purpose
- 398 -