(02)load
Load thresholds for line up or down transitions
(03)always
Second interface always Up when primary interface down(dialer)
Please Input the code of command to be excute(0-3):1
Input 1,select interface:
Key Word:
Q(quit)
(00)Serial
Serial interface
(01)Async
Asynchronous interface
Please Input the code of command to be excute(0-1): 0
Note:Input backup interface here,for example Serial.
Please input a interface name:S2/0
Note:Input interface name here, for example s2/0.
Will you excuse it? (Y/N):y
Second step, once the primary interface protocol is down, the backup interface will dial immediately on
this interface. execute the command under interface configuration.
backup always
Key Word:
Q(quit)
(00)arp set arp timeout
(01)backup Modify backup parameters
(02)bandwidth Set the interface bandwidth
......
Please Input the code of command to be excute(0-35): 1 (select backup)
Key Word:
U(undo) D(default) Q(quit)
(00)delay
Delays before backup line up or down transitions
(01)interface
Configure an interface as a backup
(02)load
Load thresholds for line up or down transitions
(03)always
Second interface always Up when primary interface down(dialer)
Please Input the code of command to be excute(0-3): 3
Input 3,select always:
Will you excute it? (Y/N):y
This section provide configuration example as below(choosing a0/0 as a dialer interface):
Configure router
interface s1/0
backup interface a0/0
backup always
11.2 HSRP Configuration
11.2.1 HSRP Summarization
HSRP is a standard method of providing high-availability by providing first-hop redundancy for IP hosts
on IEEE 802's LANs. HSRP routes IP traffic without relying on the availability of any single router. It
enables a set of router interfaces to work together to present the appearance of a single virtual router or
default gateway to the hosts on a LAN.
When HSRP is configured on a network or segment, it provides a virtual Media Access Control (MAC)
address and an IP address that is shared among a group of configured routers. HSRP allows two or
more HSRP-configured routers to use the MAC address and IP network address of a virtual router. The
virtual router does not exist; it represents the common target for routers that are configured to provide
Model Name
Command
- 448 -
Function
Backup interface always setup connection to primary
interface protocol down.