D-Link DI-1750 Reference Manual page 267

U(undo) D(default) Q(quit)
(00)A.B.C.D
Please Input the code of command to be excute(0-0): d
First input D or d，then prompt is as below:
(00)A.B.C.D
Please Input the code of command to be excute(0-0): 0
input 0，Select A.B.C.D option ，then prompt 为：
Please input a IP Address:
input IP ，prompt is as below:
(00)default-originate
......
(13)shutdown
......
Please Input the code of command to be excute(0-17): 13
input 13,Select shutdown option .
1. Configure Multi-Hop External Peer
By default, external peer group must be in network directly connected. Perform command below to
configure multi-Hop external peer group:
neighbor
ebgp-multihop ttl
In the prompt Select 12 option ，prompt is as below:
(00)A.B.C.D
Please Input the code of command to be excute(0-0): 0
input 0，Select A.B.C.D option ，then prompt 为：
Please input a IP Address:
input IP ，prompt is as below:
(00)default-originate
......
(03)ebgp-multihop
......
Please Input the code of command to be excute(0-17): 3
input 3,Select ebgp-multihop option ，prompt is as below:
(00)<1-255>
Please Input the code of command to be excute(0-0): 0
input 0，prompt is as below:
Please input a digital number:Please input a string:
input ttl value .
2. Set Administrative Distance
Administrative distance is a measure of the preference of different routing protocols. BGP uses three
different administrative distances: external, internal, and local. Routes learned through external BGP
are given the external distance, routes learned with internal BGP are given the internal distance, and
routes that are part of this autonomous system are given the local distance. To assign a BGP
administrative distance, perform the following task in router configuration mode:
distance bgp external-distance internal-distance
local-distance
In the prompt Select 5 option ，prompt is as below:
(00)<1-255>
IP address of neighbor
IP address of neighbor
Permit announcement of default route to neighbor
Shutdown neighbor
Command
{ip-address |
peer-group-name}
IP address of neighbor
Permit announcement of default route to neighbor
Allow EBGP neighbor not directly connected
Maximum hop count
Command
Administrative distance of routes
Model Name
Configure BGP neighbor to be multi-Hop
external peer group.
Assign a BGP administrative distance.
- 265 -
Purpose
Purpose