Table of Contents
Advertisement
[DEFAULT@RouterB /]# Ctrl-p
pad>clr
CLR CONF
Pad>
5.6.13 X.3 Customization Examples
The following example configures parameter 9 from 0 to 1, which adds one byte after the carriage
return. This setting is performed from a local terminal using the set parameter-number: new-value PAD
command signal.
[DEFAULT@RouterA /enable/]# pad svc 12345678
[DEFAULT@RouterB /]# ctrl-p
pad>par
PAR 1:1 2:1 3:126 4:0 5:1 6:2 7:2 8:0 9:0 10:0 11:14 12:1 13:0 14:0 15:0 16:127 17:24 18:18 19:2 20:0 21:0 22:0
pad> set 9:1
pad> par
PAR 1:1 2:1 3:126 4:0 5:1 6:2 7:2 8:0 9:1 10:0 11:14 12:1 13:0 14:0 15:0 16:127 17:24 18:18 19:2 20:0 21:0 22:0
pad>
5.6.14 X.3 Profile Example
The following example modifies and loads an existing X.25 PAD parameter profile. It accesses the
existing PAD profile ppp, changes its padding parameter (specified as 9) to a value of 2, and displays
the new parameters using the par command in PAD mode.
[DEFAULT@RouterA /enable/]# pad 3333
[DEFAULT@RouterB /]# ctrl-p
pad>prof 0
pad>par
PAR 1:1 2:1 3:126 4:0 5:1 6:2 7:2 8:0 9:2 10:0 11:14 12:1 13:0 14:0 15:0 16:127 17:24 18:18 19:2 20:0 21:0 22:0
Notes:
If the X.29 profile is set to default, the profile is applied to all incoming X.25 PAD calls, including the calls used for protocol
translation.
5.6.15 Getting Help Example
Use the help command to get short descriptions of the available parameters.
pad> help
CLR - clear X.25 connection
HELP - this help
INT - send interrupt packet over X.25 connection
PAR? - show X.3 parameters as wanted
PROF - use X.3 profile 0 or 1
QUIT - quit PAD and clear connection
RESET - send RESET packet over X.25 connection
SET - set X.3 parameters
SET? - set X.3 parameters and show it
STAT - show X.25 connection status
5.6.16 Monitoring X.25 Network Example
Following is show x25 command output example:
[DEFAULT@RouterA /enable/]# pad svc 123456789
COM
[DEFAULT@RouterB /]# ent
[DEFAULT@RouteB /enable/]#show x25
X.25/IP state
Serial1/0=UP
Model Name
- 99 -
Hide quick links:
Advertisement
Table of Contents
