D-Link DI-1750 Reference Manual page 114

(09)dialer-group
......
Please Input the code of command to be excute(0-28): 8
Key Word:
U(undo) D(default)
......
(06)load-threshold
(07)map
......
Please Input the code of command to be excute(0-11): 6
Key Word:
Q(quit)
(00)<0-100>
Please Input the code of command to be excute(0-0): 0
Please input a digital number:Please input a string:50 （input threshold value）
Key Word:
Q(quit)
(00)<0-100>
Please Input the code of command to be excute(0-0): 0
Please input a digital number:Please input a string:100 （input threshold value）
Will you excute it? (Y/N):y
Key Word:
Q(quit)
......
(21)peer
(22)ppp
......
Please Input the code of command to be excute(0-28): 22
Key Word:
U(undo) D(default)
......
(07)multilink
(08)pap
(09)timeout
Please Input the code of command to be excute(0-9): 7
Will you excute it? (Y/N):y
5.7.11 Configuring MLP on a Single ISDN BRI Interface
To enable MLP on a single ISDN BRI interface, you are not required to define a dialer rotary group
separately because ISDN interfaces are dialer rotary groups by default.
To configure an ISDN BRI interface, use the following commands beginning in global configuration
mode:
interface bri number
ip addrip-address mask [secondary]
encapsulation ppp
dialer idle-timeout seconds
dialer load-threshold load
dialer
next-hop-address[name
hostname][broadcast]
[dial-string[:isdn-subaddress]]
Q(quit)
Load threshold to place another call
Load threshold to disconnect a call
Q(quit)
Make interface multilink capable
Set PAP authentication parameters
Set PPP timeout parameters
Command
map protocol
Model Name
Assign interface to dialer-list
Specify threshold for placing additional calls
Define multiple dial-on-demand numbers
Peer parameters for point to point interfaces
Point-to-point protocol
Purpose
Define an interface
Specify an appropriate protocol address.
Enable PPP encapsulation
(Optional) Specifies a dialer idle timeout.
Specifies the dialer load threshold for bringing up
additional WAN links.
Configure dialer map
- 112 -