D-Link DI-1750 Reference Manual page 78

x25
circuit-number
x25
circuit-number
Key Word:
Q(quit)
......
(29)snmp
(30)x25
Please Input the code of command to be excute(0-30): 30
Key Word:
U(undo) D(default)
......
(06)htc
......
(19)pvc
......
Please Input the code of command to be excute(0-26): 6
Key Word:
Q(quit)
(00)<1-4095>
Please Input the code of command to be excute(0-0): 00
Please input a digital number:Please input a string:20
Will you excute it? (Y/N):y
Notes:
That the values for these parameters must be the same on both ends of an X.25 link. For connection to a public data network
(PDN), these values must be set to the values assigned by the network. An SVC range is unused if its lower and upper limits
are set to 0; other than this use for marking unused ranges, virtual circuit 0 is not available.
For an example of configuring virtual circuit ranges, see the section "Virtual Circuit Ranges Example"
later in this chapter.
5.5.7 Set the X.121 address
If your router does not originate or terminate calls but only participates in X.25 switching, this task is
optional. However, if the router is attached to a PDN, you must set the interface X.121 address
assigned by the X.25 network service provider.
To set the X.121 address, perform the following task in interface configuration mode:
Command
x25 address x121-address
Key Word:
U(undo) D(default)
......
(29)snmp
(30)x25
Please Input the code of command to be excute(0-30): 30
Key Word:
U(undo) D(default)
(00)address
(01)alias
......
Please Input the code of command to be excute(0-26): 0
Key Word:
Q(quit)
Set the highest virtual
htc
circuit number
Set the highest
pvc
permanent virtual circuit
number
Modify SNMP interface parameters
Set parameters for X.25
Q(quit)
Set the highest VC number
Set X.25 max PVC number
Highest VC number
Set the X.121 address.
Q(quit)
Modify SNMP interface parameters
Set parameters for X.25
Q(quit)
Set local X.121 address
Set address alias for this port
Model Name
1-4095
0-1024
Purpose
- 76 -
1024
0