Will you excute it? (Y/N):y
Repeat these steps for additional synchronous interfaces, if it's needed.
Notes:
To configure set-dialer rotary-group interface, the PPP configuration will automatic synchronize with corresponding dialer
interface
To configure a dialer interface, use the following commands beginning in global configuration mode:
Command
interface dialer number
ip (undo) address
dialer load-threshold load
ppp multi-link
For example:
[DEFAULT@Router /config/]#interface
Key Word:
U(undo)
D(default)
......
(08)Dialer
(09)Multilink
......
Please Input the code of command to be excute(0-11): 8
Please input a interface name:d1 (input dialer interface)
Will you excute it? (Y/N):y
Key Word:
Q(quit)
......
(15)ip
(16)mtu
......
Please Input the code of command to be excute(0-28): 15
Key Word:
U(undo)
D(default)
(00)access-group
(01)address
......
Please Input the code of command to be excute(0-18): u
Key Word:
U(undo)
D(default)
(00)access-group
(01)address
......
Please Input the code of command to be excute(0-18): 1
Key Word:
Q(quit)
(00)A.B.C.D
(01)negotiated
(02)<cr>
Please Input the code of command to be excute(0-2): 2
Will you excute it? (Y/N):y
Key Word:
Q(quit)
......
(08)dialer
Model Name
Define a dialer rotary group
Specifies no IP address for the interface.
Specifies the dialer load threshold for bringing up
additional WAN links.
Enable Multilink PPP.
Q(quit)
Dialer interface
Multilink-group interface
IP configuration commands
Set the interface MTU
Q(quit)
Specify access control for packets
IP address
Q(quit)
Specify access control for packets
IP address
IP address
IP address negotiated over PPP or via DHCP
Dial-on-demand routing (DDR) commands
- 111 -
Purpose