D-Link DI-1750 Reference Manual page 161

......
Please Input the code of command to be excute(0-10):
Specify outside interface type and number.
Step 5：
Select 18 option in the prompt, it will list all arguments:
(00)access-group
......
(09)nat
......
Please Input the code of command to be excute(0-18): 9
Input 9, select nat option, prompt is as below:
(00)inside
(01)outside
Please Input the code of command to be excute(0-1): 1
Input 1, select outside option, it will sign the interface to be connected with external network.
The previous steps are the minimum you must configure. You could also configure multiple inside and
outside interfaces.
6.3.7 Configuring Dynamic Translation
To configure dynamic inside source address translation, use the following commands in global
configuration mode:
ip nat pool name start-ip end-ip
netmask
ip access-list
access-list-name
source [source-mask]
ip nat
access-list-name pool name
interface type number
ip nat inside
interface type number
ip nat outside
Step 1.
Input ip command，it will list all arguments:
(00)access-list
......
(13)nat
......
Please Input the code of command to be excute(0-20): 13
Input 13, select nat option，prompt is as below:
(00)inside
(01)log
(02)outside
(03)pool
(04)translation
Please Input the code of command to be excute(0-4): 3
Input 3，select pool option，prompt is as below:
(00)WORD
Specify access control for packets
NAT interface commands
Inside interface for address translation
Outside interface for address translation
Command
standard
config-permit
inside source list
Named access-list
NAT configuration commands
Inside address translation
NAT Logging
Outside address translation
Define pool of addresses
NAT translation entry configuration
Pool name
Model Name
Purpose
Defines a pool of global addresses to be allocated as needed.
Defines a standard access list permitting those addresses
that are to be translated
Establishes dynamic source translation, specifying the access
list defined in the prior step.
Specifies the inside interface.
Marks the interface as connected to the inside.
Specifies the outside interface.
Marks the interface as connected to the outside.
- 159 -