D-Link DI-1750 Reference Manual page 82

x25 (undo) map ipaddress pvc
pvc_no [broadcast]
x25 (undo) map ipaddress svc
x121-address [broadcast][ebackup]
Key Word:
Q(quit)
......
(29)snmp
(30)x25
Please Input the code of command to be excute(0-30): 30
Key Word:
U(undo) D(default)
......
(11)map
(12)mod
......
Please Input the code of command to be excute(0-26): 11
Key Word:
Q(quit)
(00)A.B.C.D
(01)pad
Please Input the code of command to be excute(0-1): 0
Please input a IP Address:192.168.0.1 （input ip address）
Key Word:
Q(quit)
(00)pvc
(01)svc
Please Input the code of command to be excute(0-1): 0 （you can choose 1 to set the SVC）
Key Word:
Q(quit)
(00)<1-0>
Please Input the code of command to be excute(0-0): 0
Please input a digital number:Please input a string:100
(00)broadcast
(01)ebackup
(02)traffic-balance
(03)<cr>
Please Input the code of command to be excute(0-1): 3
Will you excute it? (Y/N):y
Ebackup means the address mapping is an enhance backup type.
Note:
Multi-protocol mapping, especially configured with broadcast, can cause particularly large
communication load which need more queues, windows and virtue circuits. User can configure the
OSPF through the command "broadcast". Refer to the chapter "X.25 and LAPB commands" for the
description of command "Map".
2. Mapping the destination X.121 address to logic virtue interface
This chapter illustrates how to make a remote PC access the local network through the
X.25 network by configuring the router.
Firstly, the remote computer access the PSTN( or directly access X.25 ) network through normal dialing
mode. The network supplier transfer the call to X.25 network through PAD( packet
assembler/disassembler). If the local router is configured to map the destination X.121 address to the
logic virtue interface, it will response the call and transfer the call to the PPP which will perform the
authentication, registration, authorization and so on. The remote computer can access the local
network if it pass the authenticaiton.
Model Name
Add/delete an permanent virtue circuit mapping.
Add/delete a switched virtue circuit mapping.
Modify SNMP interface parameters
Set parameters for X.25
Q(quit)
Set map from IP address to X.121 address
Set LAPB and X.25 module(8/128)
IP address
pad links
Map to PVC
Map to SVC
PVC number
send broadcasts to this host
enable ebackup to this host
enable traffic balance to this host
- 80 -