D-Link DI-1750 Reference Manual page 183

6.4.4 DHCP Client Configuration Task List
Before any DHCP is configured, you must ensure that there is at least one DHCP-Server residing in the
network the router reachable. Next section will show you how to executing the following optional tasks
through DHCP:
♦ Obtain an IP for an Ethernet interface.
♦ Specify the DHCP-Server address.
♦ Configure DHCP parameters.
♦ Obtain an IP from DHCP-Server for PPP mutual process
♦ Monitor DHCP.
6.4.5 Obtain an IP for an Ethernet Interface
Perform the following command on an Ethernet interface to obtain an IP for this interface on the router
through DHCP:
Command
ip address dhcp
Select 20 option in the prompt，prompt is as below:
(00)access-group
(01)address
(02)beigrp
......
Please Input the code of command to be excute(0-19): 1
input 1，Select address option ，prompt is as below:
(00)A.B.C.D
(01)dhcp
Please Input the code of command to be excute(0-1): 1
input 1，Selectd hcp option .
6.4.6 Specify DHCP-Server
If you have known some DHCP-Server addresses, you can specify these Server addresses on the
router to reduce the interaction and time of protocol processing. Perform the following command in
global configure directory:
Command
ip dhcp-server ip-address
input ip Command，prompt is as below:
(00)access-list
......
(04)dhcp-server
......
Please Input the code of command to be excute(0-20): 4
input 4，Selectd hcp-server option ，prompt is as below:
(00)A.B.C.D
Please Input the code of command to be excute(0-20): 0
input 0，SelectA.B.C.D option ，prompt is as below:
Please input a IP Address:
input IP.
When processing "Obtain an IP for an Ethernet Interface", this command is optional.
Specify using DHCP to configure IP address for the Ethernet
interface.
Specify access control for packets
IP address
Enhanced Interior Gateway Routing Protocol
IP address
IP Address negotiated via DHCP
Specify the IP address of a DHCP-Server.
Named access-list
Specify address of DHCP server to use
IP address of DHCP Server
Model Name
Function
Function
- 181 -