D-Link DI-1750 Reference Manual page 110

Hide thumbs Also See for DI-1750:
Table of Contents

Advertisement

{begin-ip-address
[ip-address-number]}
interface type number
peer
addrip-address
Key Word:
U(undo)
......
(25)peer
(26)physical-layer
......
Please Input the code of command to be excute(0-35): 25
Key Word:
U(undo)
(00)default
(01)neighbor-route
Please Input the code of command to be excute(0-1): 0
Key Word:
Q(quit)
(00)ip
Please Input the code of command to be excute(0-0): 0
Key Word:
Q(quit)
(00)address
Please Input the code of command to be excute(0-0): 0
Key Word:
Q(quit)
(00)A.B.C.D
(01)dhcp
(02)pool
Please Input the code of command to be excute(0-2): 0
Please input a IP Address:192.168.0.1 (input ip address)
Will you excute it? (Y/N):y
5.7.8 Disabling or Reenabling Peer Host Routes
The D-Link router automatically creates neighbor routes by default; that is, it automatically sets up a
route to the peer address on a point-to-point interface when the PPP IPCP negotiation is completed.
To disable this default behavior, or to reenable it once it has been disabled, use the following
commands in interface configuration mode:
peer (undo) neighbor-route
peer neighbor-route
Key Word:
Q(quit)
......
(24)pdp
(25)peer
......
Please Input the code of command to be excute(0-35): 25
Key Word:
U(undo)
D(default)
(00)default
(01)neighbor-route
default
config-ip
D(default)
Q(quit)
Configure physical layer parameters
D(default)
Q(quit)
Specify default parameters
Create neighbor route to peer if needed
Specify default IP parameters
Specify default IP address
Default IP address for remote end of this interface
Use DHCP proxy client to allocate a peer IP address
Use IP pool mechanism to allocate a peer IP address
Command
pdp configuration commands
Peer parameters for point to point interfaces
Q(quit)
Specify default parameters
Create neighbor route to peer if needed
Model Name
Specifies the interface and enters interface
configuration mode.
Specifies the specified address.
Peer parameters for point to point interfaces
Purpose
Disables creation of neighbor routes.
Reenables creation of neighbor routes.
- 108 -

Advertisement

Table of Contents
loading

This manual is also suitable for:

Di-2621Di-2630Di-3660

Table of Contents