D-Link DI-1750 Reference Manual page 328

7.4.5 Configure the condidate RP
PIM-SM can not work without RP, so there must be at least one candidate RP.
To enable this function, use this command under the global configuration mode.
To disable it, use the no form.
ip pim-sm
number] [interval|group-list acl-name]
no ip pim-sm
number]
Input ip on the global configuration mode ,clew:
(00)access-list
......
(20)pim-sm
......
Please Input the code of command to be excute(0-27): 20
Key Word;
(00)accept-register
......
(08)rp-candidate
Please Input the code of command to be excute(0-8):8
Key Word;
(00)interface-name
Please Input the code of command to be excute(0-8):0
Choose the relevant port.
If necessary, clew continually the following related key word option.
7.4.6 Show PIM-SM mrouting information
To display the mrouting information of PIM-SM, use this command.
show ip mroute pim-sm [group-address]
[source-address] [type number] [summary]
[count] [active kbps]
Input show on the any mode ,clew:
(00)alias
......
(18)ip
......
Please Input the code of command to be excute(0-46): 18
Key Word;
(00)access-list
......
(14)mroute
Please Input the code of command to be excute(0-29):14
Key Word;
(00)dvmrp
......
(04)pim-sm
......
Please Input the code of command to be excute(0-8):4
Command
rp-candidate [type
[type
rp-candidate
Named access-list
PIM Sparse Mode
......
candidate RP router (CRP)
Command
alias for command
IP Configuration Information
list IP access lists
IP multicast routing table
......
PIM Sparse Mode
Model Name
Function
Configure the router to be a candidate RP.
Disable the router to be a candidate RP.
Function
Display PIM-SM mrouting information.
- 326 -