D-Link DI-1750 Reference Manual page 399

queue-list 5 protocol ip 6 gt 1000
9.2.9 Configure PQ
If you want to configure PQ to an interface, you can use the command below in interface configuration
mode after the interface specified:
Command
priority-group list-number
If you want to configure PQ on an interface, you can select priority-group in the interface commands
under the global configuration directory after specifying the interface.
Key Word:
U(undo) D(default) Q(quit)
(00)<1-16> priority list number
Please Input the code of command to be excute(0-0):0
Input 0 and select <1-16>option, input the list number at prompt:
Please input a digital number:2
Note： Input 1-16 list numbers here, 2 is only for example.
Will you excute it? (Y/N):y
9.2.10 Configuring Priority Queueing List
The customed queueing can define the priority queueing lists, and specify the maximum number of the
queues. When applying the list to an interface, you can adjust the parameters according to the list.
To specify the maximum number of the queues, use one of the following commands in global
configuration mode:
priority-list list-number queue-limit
high-limit middle-limit normal-limit
low-limit
To configure an upper limit for a PQ list, you can use this command in the global configuration directory:
[DEFAULT@Router /config/]#priority-list
Key Word:
U(undo) D(default) Q(quit)
(00)<1-16> priority list number
Please Input the code of command to be excute(0-0): 0
Input 0, select <1-16>option and input the PQ list number at prompt:
Please input a digital number:1
Note： Input 1-16 PQ numers here, 1 is only for example.
Key Word:
Q(quit)
(00)interface
(01)protocol
(02)queue-limit set queue limit for priority queue
(03)default
Please Input the code of command to be excute(0-3): 2
Input 2 and select<queue-limit> option:
Key Word:
Q(quit)
(00)<0-32767> High limit
Applying PQ to the interface, list-number is the number
of the adopted customed queue list. The list argument is
any number from 1 to 16. There is no default
assignment.
Command
Establish priorities for packets from a named interface
Establish priorities for packets of a protocol
set custom queue for unspecified packets
Model Name
Purpose
Purpose
Specifies the maximum number of packets allowed in
each of the priority queues. high-limit 20, medium-limit
40, normal-limit 60, low-limit 80.
- 397 -