D-Link DI-1750 Reference Manual page 118

To set up the dialer rotary interface, use the following commands:
Command
interface dialer number
ip address ip-address mask
encapsulation ppp
dialer idle-timeout seconds
dialer load-threshold load
dialer map
next-hop-address[name
hostname][broadcast]
[dial-string[:isdn-subaddress]]
dialer-group group-number
ppp
[pap|chap|ms-chap]
ppp multilink
[DEFAULT@Router /config/]#interface
......
(08)Dialer
(09)Multilink
(10)Virtual-template
(11)Virtual-tunnel
Please Input the code of command to be excute(0-11): 8
Please input a interface name:d1 （input dialer interface name，this is just an example）
Will you excute it? (Y/N):y
Key Word:
U(undo) D(default)
......
(19)ip
(20)mtu
......
Please Input the code of command to be excute(0-32): 19
Key Word:
U(undo) D(default)
(00)access-group
(01)address
(02)beigrp
......
Please Input the code of command to be excute(0-18): 1
(00)A.B.C.D IP address
(01)negotiated IP address negotiated over PPP or via DHCP
Please Input the code of command to be excute(0-1): 0
Please input a IP Address:192.168.1.1 255.255.255.0 （input ip address，this is just an example）
(00)secondary Make this IP address a secondary address
(01)<cr>
Please Input the code of command to be excute(0-1): 1
Will you excute it? (Y/N):y
Key Word:
U(undo) D(default)
......
Model Name
Define an interface
Specify an appropriate IP address.
Enable PPP encapsulation
(Optional) Specifies the dialer idle timeout
period.
Configure the maximum load threshold specified
by the dialer.
protocol Configure dialer map.
Controls access to this interface by adding it to a
dialer access group.
(Optional) Enables PPP authentication.
authentication
Enable Multilink PPP.
Dialer interface
Multilink-group interface
Virtual template interface
Virtual tunnel interface
Q(quit)
IP configuration commands
Set the interface MTU
Q(quit)
Specify access control for packets
IP address
Enhanced Interior Gateway Routing Protocol
Q(quit)
- 116 -
Purpose