Table of Contents
Advertisement
dial dialing numlen dialing-time
dial timeout time1 time2
The first parameter of the first command is default phone number length and the second parameter is
the dialing times allowed in a dial process. The first parameter of the second command is the wait time
of first dial and the second parameter is the wait time of whole dial. In default case the length of phone
number is 10 and the dialing times is 3.
4. Configure the balance prompt tone and the cost rate
You will care the balance on your card as using card phone, thus there is a problem of balance query.
But you may be bored by the whiny balance prompt, then you can use balance prompt switch. Please
perform the following configuration in ivr configure mode:
account-audio
No account-audio is configured by default.
Configure the money amount corresponding to seconds in the relevant server. In fact what stored in the
server are all the seconds the user can communicate. When offering balance query they are needed to
be translated into money. The cast rate is configured for the translation. Please perform the following
configuration in ivr configure mode:
account-rate rate
Cost rate is 3 cents per 6-second.
5. Configure ivr direct authentication mode
Configuration in IVR dial-peer
To configure direct authentication mode, you must first configure pattern name and ivr access number
in dial-peer configure mode. Please perform the following configuration in dial-peer configure mode:
destination-pattern des-num
app ivrl_direct_authen
Configure dial information
You can configure the length of called number, the wait time of first dial and whole dial. The length of
called number doesn't include ending key.
The period from usr starting dial to actually press key is called first dial wait time. The period from user
first pressing to ending dial is called whole dial wait time. You can configure the wait time of first dial
and whole dial. What you should care is that this command will take effect on dial length and wait time
of all patterns. Please perform the following configuration in ivr configure mode:
Please perform the following configuration in ivr configure mode:
dial dialing numlen dialing-time
Command
Configure the length of called number and the times of re-dial.
Configure the wait time of first dial and whole dial.
Command
Configure voice balance prompt.
Command
Configure the money corresponding to per 6-second. The unit
is cent.
Command
Configuring ivr connection service number.
Configuring ivr mode into direct authentication mode.
Command
Configure the default called number length and the re-dial
times.
Model Name
Function
Function
Function
Function
Function
- 480 -
Hide quick links:
Advertisement
Table of Contents
