D-Link DI-1750 Reference Manual page 279

6.13.1 How to Enable RSVP on Router
User should configure the interface on which RSVP will be enabled in command to enable RSVP on
router. This can be implemented with commands of RSVP interface configuration. If user completes
upper configurations on all interfaces wanted RSVP, RSVP will function on these interfaces.
To enable RSVP on an interface, perform the following task in global configuration mode:
ip rsvp bandwidth [interface-kbps] [single-flow-kbps]
In the prompt Select ip option ，then prompt is as below:
(00)access-group
......
(14)rsvp
......
Please Input the code of command to be excute(0-18): 14
input 14，Select rsvp option ，prompt is as below:
(00)bandwidth
(01)tos
(02)precedence
(03)neighbor
Please Input the code of command to be excute(0-3): 0
input 0，Select bandwidth option ，prompt is as below:
(00)<1-1000000>
Please Input the code of command to be excute(0-0): 0
input 0， and confirm itinterface-kbps value ，prompt is as below:
(00)<1-1000000>
Please Input the code of command to be excute(0-0): 0
input 0， and confirm itsingle-flow-kbps value .
Note:
When using ip rsvp bandwidth command, if interface-kbps and single-flow-kbp are omitted, the whole port can apply for
upper limit of reservation resource, and single data flow can apply for an upper limit of reservation resource which is 75% of
port resource by default.
6.13.2 How to Enable RSVP in IP Phone Module
Before configuring D-LINK IP Phone and D-LINK IP Phone module as well as use Voice over IP, user
must enable RSVP in command to configure resource reservation for voice flow with RSVP:
Do configure RSVP commands on the port needing RSVP configuration because RSVP is disabled on
port by default. (Refer to last section for usage.)
Because IP Phone disables QOS by default, user should enable QOS in dial-peer voip.
Use command below in dail-peer configuration state to enable RSVP on port f0/0:
req－qos｛guarantee | load｝{flow
Note:
In the default of guarantee | load, resource reservation form is guarantee. In the default of flow-kbps, reservation bandwidth
is 24kbps.
Command
Specify access control for packets
RSVP interface command
RSVP interface bandwidth setting
RSVP TOS setting
RSVP precedence setting
RSVP neighbor setting
Amount of bandwidth (in kbps) on interface to be reserved
Amount of bandwidth (in kbps) allocated to a single flow
Command
－
kbps}
Model Name
Configure RSVP on network interface.
Configure bandwidth for IP Phone voice
flow.
- 277 -
Purpose
Purpose