D-Link DI-1750 Reference Manual page 505

Please Input the code of command to be excute(0-4): <cr>
Select the configuration interface of the SDLC station to be displayed
14.3.12 Configuration Examples
The following sections provide SDLC configuration examples:
♦ SDLC Two-Way Simultaneous Mode Configuration Example
♦ SDLC Configuration for DLSw+ Example
♦ Half-Duplex Configuration Example
♦ sdlc Configuration Example
♦ sdlc Configuration Example
1. SDLC Two-Way Simultaneous Mode Configuration Example
The following configuration defines serial interface 0 as the primary SDLC station with two SDLC
secondary stations, C1 and C2, attached to it through a modem-sharing device. Two-way simultaneous
mode is enabled.
config-interface serial 0
config-encap sdlc-primary
config-sdlc address c1
config-sdlc address c2
sdlc simultaneous full-datamode
The network for this configuration is shown in Figure 126.
Figuer 14-1 Two SDLC Secondary Stations Attached to a Single Serial Interface through a Modem-Sharing
2. SDLC Configuration for DLSw+ Example
The following example describes an SDLC configuration if you plan to implement DLSw+ support. In
this example, 4000.3745.001 is the MAC address of the host. The router serves as the primary station
for the remote secondary stations, c1 and c2. Both c1 and c2 are reserved for DLSw+ and cannot be
used by any other data link user.
config-interface serial 0
config-encap sdlc
config-sdlc vmac4000.3174.0000
config-sdlc address c1
config-sdlc xid c1 01712345
config-sdlc partner 4000.3745.0001 c1
config-sdlc address c2
config-sdlc xid c2 01767890
config-sdlc partner 4000.3745.0001 c2
config-sdlc role primary
Model Name
Figure 126
Device
- 503 -