D-Link DI-1750 Reference Manual page 11

♦ Asynchronous Serial
♦ Channelized E1
♦ ISDN PRI interface
♦ ISDN BRI interface
♦ DTU interface
♦ Asynchronous MODEM interface
Presently, the logic interface supported by D-Link Router are:
♦ Loop-back interface
♦ Empty interface
♦ Dialup interface
♦ Virtual template and virtual access interface
♦ Tunnel interface
♦ Sub-interface
3.2 Introduction of Interface Configuration
These following instructions apply to all interface configuration processes. Users should begin interface
configuration in global configuration mode and follow these steps:
Use the command "interface" to begin to configure the related interface parameters. User can use
command "show interface" to display the interface. All the interfaces of the device will provide theirs
status as follows:
[DEFAULT@4_2750 /enable/]#show
(00)alias
......
(19)interface
......
Please Input the code of command to be excute(0-45): 19
Input 17，choose "interface"，it will prompt：
(00)FastEthernet
(01)Ethernet
(02)Serial
(03)Async
(04)Null
Please Input the code of command to be excute(0-4): 2
Input 2，choose "Serial"，the prompt will be：
Please input a interface name:s1/0
Input the value of type、slot and port of the interface，it will display：
Serial 1/0 is administratively down, line protocol is down
Hardware is SCC Mode=Sync,Speed=64000
DTR=UP,DSR=DOWN,RTS=DOWN,CTS=DOWN,DCD=DOWN
MTU 1500 bytes, BW 64 kbit, DLY 20000 usec
Encapsulation HDLC, loopback not set
Keepalive set(10 sec)
If you want to configure the serial interface 1/0, input the following content:
[DEFAULT@router /config/]#interface
Key Word:
U(undo) D(default) Q(quit)
(00)FastEthernet FastEthernet interface
(01)Ethernet Ethernet interface
(02)Serial Serial interface
alias for command
interface status and configuration
FastEthernet interface
Ethernet interface
Serial interface
Asynchronous interface
Null interface
Model Name
- 9 -