D-Link DI-1750 Reference Manual page 94

[DEFAULT@Router /enable/]#cd config
[DEFAULT@Router /config/]#interface s1/0
[DEFAULT@Router /s1/0/]#ip address 168.173.24.3 255.255.255.0
! connect to public packet network and make the router operate as DTE:
[DEFAULT@Router /s1/0/]#encapsulation x25
[DEFAULT@Router /s1/0/]#x25 address 30561003
[DEFAULT@Router /s1/0/]#x25 htc 32
[DEFAULT@Router /s1/0/]#x25 map 168.173.24.1 svc 30561001
[DEFAULT@Router /s1/0/]#x25 map 168.173.24.2 svc 30561002
5.5.19 Configuring the virtue circuit ranges
Perform the following commands to set the router's interface serial 1/0 to be encapsulated with X.25,
and the ranges of virtue circuit are: PVC [1,8] ,SVC [9,64].
[DEFAULT@Router /enable/]#cd config
[DEFAULT@Router /config/]#interface s1/0
[DEFAULT@Router /s1/0/]#encapsulation x25
[DEFAULT@Router /s1/0/]#x25 htc 64
[DEFAULT@Router /s1/0/]#x25 pvc 8
5.5.20 Configuration example of XOT based on PVC
The configuration commands and arrangement plan are as follows:
Configuring router B1:
[DEFAULT@Router /s1/1/]#ip address 8.0.0.1 255.0.0.0
[DEFAULT@Router /s1/1/]#enc x25
[DEFAULT@Router /s1/1/]#x25 interface dce
[DEFAULT@Router /s1/1/]#x25 pvc 2
[DEFAULT@Router /s1/1/]#x25 map 8.0.0.10 pvc 1
Configure router C1:
[DEFAULT@Router /f0/0/]#ip address 192.168.20.92 255.0.0.0
[DEFAULT@Router /s1/0/]#ip address 8.0.0.2 255.0.0.0
[DEFAULT@Router /s1/0/]#enc x25
[DEFAULT@Router /s1/0/]#x25 pvc 2
[DEFAULT@Router /config/]#x25switch xot pvc serial 1/0 1 serial 1/1 1 192.168.20.22
Configuring router C2
[DEFAULT@Router /f0/0/]#ip address 192.168.20.22 255.0.0.0
[DEFAULT@Router /s1/1/]#ip address 8.0.0.11 255.0.0.0
[DEFAULT@Router /s1/1/]#enc x25
[DEFAULT@Router /s1/1/]#x25 pvc 2
[DEFAULT@Router /config/]#x25switch xot pvc serial 1/1 1 serial 1/0 1 192.168.20.92
Configuring router B2:
[DEFAULT@Router /s1/0/]#ip address 8.0.0.10 255.0.0.0
[DEFAULT@Router /s1/0/]#enc x25
[DEFAULT@Router /s1/0/]#x25 interface dce
Model Name
Figuer 5-8 arrangement plan of XOT based on PVC
- 92 -