D-Link DI-1750 Reference Manual page 469

connection-plar STR
description STR
output-gain NUM
Shutdown
12.6.2 E&M port special configure
Considering different configuration of different PBX products, we show you about the usual configure
commands when configuring E&M port.
operation {2-wire | 4-wire }
emsignal-in
|delay-dial}
emsignal-out{immediate|
delay-dial}
type {1 | 2 | 3 | 5}
12.6.3 FXO port special configure
As using FXO port you should first examine the switch frequency and accommodate it.
As using FXO port you are usually needed to sense the switch frequency and tune the frequency.
(Refer to "About DSP sensing switch signaling tone" for detailed specification.)
sense cptone port slot/port dial [str]
tone_type freq_type
cptone slot
（Note: Command sense is used in global mode.
12.7 Voice over IP Configuration Examples
The actual Voice over IP configuration procedure you complete depends on the actual topology of your
voice network. The following configuration examples should give you a starting point. Of course, these
configuration examples would need to be customized to reflect your network topology.
Configuration procedures are supplied for the following scenarios:
♦ FXS-to-FXS Connection
♦ PSTN Gateway Access Using FXO Connection
These examples are described in the following sections.
Model Name
Command
{immediate|
wink-start
wink-start
Command
occurring between the both sides.
After receiving the hanging up of the other side on voice port,
it will evoke a VOIP call by the port according to the hot line
dialing configured on the port.
Add specification on specified voice port so that the
configurator won't be confused as operating.
Configure the volume played to the user on voice port.
Disable the current voice port.
Function
Configuring the wiring system linked to the voice
port.
Configuring the signaling employed on the port when
the switch calls the local port.
| Configuring the signaling employed on the port when
the local port calls the switch.
Configuring the mode of connection of the voice port.
Function
The command is used for detecting the frequency
and wave pattern of various signaling tones of the
switch connected with router FXO port directly or
indirectly. By setting the different dial_string and
making the corresponding operation (similar to the
operation of ordinary telephone) at the time of
detection, the various signaling tones on the different
switches can be detected.
Setting the parameter configuration of the signaling
tone of some slot, at this moment, all the ports on the
slot shall be under idle state.
- 467 -