D-Link DI-1750 Reference Manual page 389

(16)fair-queue enable fair queue on interface
(17)help Description of the interactive help system
(18)history look up history
(19)interface interface configuration
(20)ip IP configuration commands
(21)keepalive Enable keepalive
(22)llc2 Setup LLC2(Logic Link Control Type2) parameters
(23)no negate configuration
(24)pdp pdp configuration commands
(25)physical-interface Configure lan physical interface
(26)pppoe-client pppoe client enable
(27)priority-group Assign a priority group to interface
(29)random-detect enable weighted random early detect on interface
(30)router routing protocol configuration
(31)service-policy Assign a priority group to interface
(32)show show configuration and status
(33)shutdown Shutdown the current interface
(34)snmp Modify SNMP interface parameters
(35)speed Configure speed operation
Please Input the code of command to be excute(0-35): 16（select fair-queue）
Will you excute it? (Y/N):y
Note: WFQ is the default queueing mode on interfaces that run at or below E1 speeds (2.048 Mbps or
less). It is enabled by default for physical interfaces that do not use Link Access Procedure Balanced
(LAPB) or X.25 encapsulations.
9.2.3 Configure Policy Map On An Interface (CBWFQ)
After configure a policy map, CBWFQ will take effect on the interface. To configure a policy map on the
interface which you have specified, you can use the following commands in interface configuration
mode:
Command
service-policy policy-name
Select service-policy command in the directory of configure interface
Key Word:
U(undo) D(default) Q(quit)
(00)WORD policy-map name
Please Input the code of command to be excute(0-0): 0
Input 0 to select WORD option, input policy map name at prompt:
Please input a string:name
ut the policy map name here, name is only for example.
Note： Inp
Will you excute it? (Y/N):y
Note：This command is only available in the interfaces that have configured WFQ algorithm.
9.2.4 Configure Policy Map
By configuring the policy map and the class map that embodied in it, a group of flow with different type
can be specified. When an interface uses the policy map, certain QoS can be ensured according to the
specified flow type.
In command to configure policy map, you need enter policy map configuration mode by using the
command below in global configuration mode:
Command
policy-map policy-name
Model Name
Purpose
specifying the interface using command set-policy-map
Purpose
enter policy map configuration mode to configure policy
- 387 -