D-Link DI-1750 Reference Manual page 494

Input 8，select <tpf-time> item
Key Word:
Q(quit)
(00)<1-60> seconds -- the time interval for a response PDU(F=1)
Please Input the code of command to be excute(0-0): 0
Please input a digital number:12
Input 12，set the wait peer response time as 12s.
Will you excute it? (Y/N):y
14.2.5 Configure the reject-time
llc2 trej-time seconds
llc2 (undo) trej-time
Note:
When an LLC2 station sends an information frame, a sequence number is included in the frame. The LLC2 station that
receives these frames will expect to receive them in command. If it does not, it can reject a frame and indicate which frame it
is expecting to receive instead. Upon sending a reject, the LLC2 station starts a reject timer. If the frames are not received
before this timer expires, the session is disconnected.
Select the IIC2 commands from the interface commands of the global configuration list, all IIC2
selection as fellow:
Key Word:
U(undo) D(default) Q(quit)
(00)ack-max the Max I-frames received before sent acknowledgment
(01)ack-delay-time the Max time to delay the acknowledgment of I-frames
(02)holdqueue the max queue lenght
(03)idle-time the timer for idle
(04)local-window the local window size
(05)n2 the retrying counts
(06)t1-time the timer of receiving an acknowledgment
(07)tbusy-time the timer of re-querying remote busy
(08)tpf-time the timer of receive a response PDU(F=1)
(09)trej-time the timer of receiving a reply to a sent REJ PDU
Please Input the code of command to be excute(0-9): 9
Input 9，select <trej-time> item
Key Word:
Q(quit)
(00)<1-60> seconds -- the time interval for a reply to a sent REJ PDU
Please Input the code of command to be excute(0-0): 0
Please input a digital number:12
Input 12，set the reject time as 12s
Will you excute it? (Y/N):y
14.2.6 Configure the LLC2 window size
Model Name
Command
Command
This command is used to control the amount of time a
router waits for a correct frame after sending a reject
(REJ) command to the remote LLC2 station.
Number of seconds (s) the router waits for a resend of a
rejected frame before sending a reject command to the
remote station. The minimum is 1 s. The maximum is
60s.The default value is 3s.
Cancel the configuration
- 492 -
Function
Function