D-Link DI-1750 Reference Manual page 304

In parameter clew choose the 17th option, clew:
(00) access-group
......
(15) pim-dm
......
Please Input the code of command to be excute(0-22): 15
Input 15，choose pim-dm option.
7.2.3 IGMP speciality configuration task list
The configuration commands of IGMP-Router port speciality mainly are adjust IGMP parameter
command, following we will introduce the basic configuration command of IGMP-Router port. If you
want to understand all the implement command of IGMP-Router port, please refer to the IGMP
command explain document.
7.2.4 Change IGMP version of present running
Since IGMP has been brought forward, there has been three official versions, corresponding to rfc1122,
rfc2236, rfc3376. Thereinto, IGMP version 1 has just implemented the simplest multicast-group
member record function; version 2 has implemented query function which aim at the specified
multicast-group member and Leave message that IGMP host leave the specified multicast-group,
reduce the delay of the group member change; version 3 has more implemented update and
maintenance which corresponding to multicast-group member identity of the host source address,
additional, version 3 IGMP Router has been fully compatible with the host port of version 1 and version
2,our router software system provides complete support for the IGMP Router port protocol of the
three versions.
Since IGMP aims at configuration of router port, i.e. it could configure separately IGMP-Router port
function (started by multicast-group route protocol which is configured on different port) on the different
port, and could run different version IGMP on the different port.
Note: for the specified multicast-group router, on the different ports which connected to the same
network, you could start the IGMP-Router function on one port.
If you want to change the IGMP-Router port protocol version, which is running on the port, and you can
use the following command under the port configuration.
Command
ip igmp
version_number
Choose the 17th option in the parameter clew, notify
(00)access-group
......
(06)igmp
......
Please Input the code of command to be excute(0-22): 6
input 6,choose igmp option, notify
......
(07)static-group
(08)version
Please Input the code of command to be execute (0-8): 8
input 8，choose version option ，notify：
(00)<1-3> the IGMP version number on the interface
Please Input the code of command to be execute (0-8):
Choose version.
Model Name
Specify access control for packets
PIM-DM interface commands
Change the version of IGMP which is running on
version
current port
Specify access control for packets
IGMP interface command
IGMP static multicast group
the IGMP version on the interface
- 302 -
Purpose