Juniper ACX1000 Configuration Manual page 316

ACX Series Universal Access Router Configuration Guide
Requirements
Overview
Configuration
258
NOTE: ACX5048 and ACX5096 routers do not support ordinary clock.
Requirements on page 258
Overview on page 258
Configuration on page 258
This example uses the following hardware and software components:
NOTE: This example also applies to QFX Series switches. QFX Series switches
do not support Gigabit Ethernet interfaces. Instead, configure PTP boundary
clock parameters on 10-Gigabit Ethernet interfaces.
One ACX Series router
Junos OS Release 12.2 or later
In this configuration, the ordinary slave clock uses unicast-negotiation and compensates
for some network asymmetry.
NOTE: The values in this example are for illustration purposes only. You can
set the values for each parameter according to your requirements.
To configure an ordinary slave clock with unicast-negotiation, perform these tasks:
Configuring an ordinary slave clock with unicast-negotiation on page 259
Results on page 260
Copyright © 2017, Juniper Networks, Inc.