Juniper ACX1000 Configuration Manual page 320

ACX Series Universal Access Router Configuration Guide
CLI Quick
Configuration
Step-by-Step
Procedure
262
set protocols ptp clock-mode ordinary
set protocols ptp ipv4-dscp 46
set protocols ptp slave interface ge-0/2/0.0 unicast-mode transport ipv4
set protocols ptp slave interface ge-0/2/0.0 unicast-mode clock-source 12.1.1.4
local-ip-address 12.1.1.5
Configuring an ordinary slave clock without unicast-negotiation
Configure the clock mode:
1.
[edit protocols ptp]
user@host# set clock-mode ordinary
Configure the Differentiated Services code point (DSCP) value for all PTP IPv4
2.
packets originated by the device:
NOTE: The
switches.
[edit protocols ptp]
user@host# set ipv4-dscp 46
Configure the slave interface:
3.
[edit protocols ptp]
user@host# edit slave interface ge-0/2/0.0
Configure the unicast transport mode:
4.
[edit protocols ptp slave interface ge-0/2/0.0]
user@host# set unicast-mode transport ipv4
Configure the clock source:
5.
[edit protocols ptp slave interface ge-0/2/0.0]
user@host# unicast-mode clock-source 12.1.1.4 local-ip-address 12.1.1.5
Verify the configuration:
6.
[edit protocols ptp slave interface ge-0/2/0.0]
user@host# top
[edit]
user@host# edit protocols
[edit protocols]
user@host# show
See the output for the
statement is not supported on QFX Series
ipv4-dscp 46
show command in the Results section.
Copyright © 2017, Juniper Networks, Inc.