Error Messages And Troubleshooting - Omron FZ4 Series User Manual

Error Messages and Troubleshooting

This section lists error messages that display on the screen and solutions.
When a message with this symbol is displayed, the ERROR signal on the parallel interface is on.
Error message
No value set. Please
A value must be set for this item. Please set up value.
set value.
Do the following errors exist in settings for an expression set up?
●
Error of the expression.
●
●
●
Cannot add object. Out
of range of specified Incompliant to the conditions of expression. Please check the content.
characters of Reference:
expression.
Is the camera cable connected to the controller?
The problem occurred
Is camera cable disconnected?
in the camera
Do [Select camera] of [Camera Image Input] and [Camera Switching] have any errors?
connection.
Please check the contents of [Camera setting], then switch off and restart.
Reference:
Because memory available for use was insufficient, memory needed to open the window
could not be secured. Check the flow by adjusting the measurement region of each
processing unit and the sizes of the registered models.
Failed to start the
●
window. Memory is
insufficient.
Warning range shall be
Please redefine the upper and lower warning range limits such that they are within the range
set within the range
between the lower and upper evaluation limits.
from judgement lower
Reference:
to upper limit.
Insufficient memory may occur during measurement. Reset the model parameters.
The "Search"
●
measurement result
may be "NG
●
(Insufficient memory)"
with the current setting.
●
The problem occurred
This is displayed when the significant abnormality occurs in the controller system. Please
in the system.
contact one of our branches or regional offices.
The problem occurred
in system date. The
Low battery (for the backup of date and time data) level. The batteries need to be
system battery is
replaced. Please return old batteries to one of our branches or regional offices.
insufficient.
Is a USBDisk set to the controller?
Failed to switch scene
A USBDisk is needed to read scenes after scene group 1.
FZ4 User's Manual
Different number of open/close parentheses
TJG/unit/value/function/operator/comma is lined next to each other.
Operator is set at beginning or end of expression
The number of function operands is insufficient or there are more than is needed
"Processing Item List Manual", "Setting (Calculation)" (p.452)
Setting Conditions for Camera Use (p.342)
[Shape search]
If shape search+ setup window is opened while the RAMDisk memory is insufficient
for image logging, etc. on the RAMDisk, a warning message is displayed. In the case
that an image logging file is stored in a RAMDisk, please move the content on the
RAMDisk to a USBDisk to open up memory and reopen the set up window.
"Processing Item List Manual", "Judgement conditions (Trend Monitor)" (p.510)
[Search]
Reference: "Processing Item List Manual", "Judgement is NG (Insufficient Memory)" (p.66)
[Flexible search]
Reference: "Processing Item List Manual", "Judgement is NG (Insufficient Memory)" (p.77)
[Classification]
Reference: "Processing Item List Manual", "Judgement is NG (Insufficient Memory)" (p.148)
Remedy
Error Messages and Troubleshooting
8
571