Non-Stop Adjustment Mode - Omron FZ4 Series User Manual

Important
If Ethernet is used, set a different port number for each line.
●
RS-232C/422 can be set at line 0 only.
●
If parallel communication is used, the I/O format changes.
●
1
Reference:
Parallel communication can only be set at line 0. Line 1 uses the settings of line 0.
●
Date-time setting, language setting and operation mode setting can be set at line 0 only.
●
If STEP is input to line 0 and line 1 at exactly the same time, measurement on one side may be delayed
●
(approximately by a time corresponding to the camera image input unit).
Error messages are the same. If an error occurs on either line, an error message is displayed.
●
If logging is performed for line 0 and line 1 at the same time, measurement may take a longer time.
●
User data of line 1 is saved in the controller.
●

Non-stop Adjustment Mode

The measurement flow can be changed and adjusted during operation without stopping the
measurement process.
Set images using saved image files. The modified measurement flow can be reflected during operation.
Utilization example of non-stop adjustment
1.
In the "Control" area of the Main screen (RUN window), tap [Tool box].
2.
Tap [Enter non-stop adj.].
Transfers to non-stop adjustment mode. Measurement will continue without stopping.
38 Setting Operation Mode
I/O Format (Parallel Interface) (p.543)
FZ4 User's Manual