Omron FZ4 Series User Manual page 505

<Command format>
<Response format>
When processing is performed normally
When processing is not performed normally
<Parameters explanation>
Scene group No. Specifies the scene group No. after switching (0 to 31).
(Example)
When switching to scene group 2
<Command>
<Response>
Important
During parallel continuous measurement and when the STEP signal is input continuously, do not perform
●
switching of the scene group. When this is performed, set "Unchecked" in "Save scene group on switch scene"
in either of the settings items below.
Switch Scene Group window Reference:
●
[Measure setting] in the [Measure] menu Reference: Setting Conditions Related to Operation during Measurement (p.344)
●
SCNLOAD
Reads scene data.
<Command format>
FZ4 User's Manual
Switching Scene Groups (p.65)
Controlling/Outputting through Serial Communication (Non-procedure)
7
503