Omron FZ4 Series User Manual page 491

MEASUREUNIT or MTU
Performs a test measurement on the specified unit.
<Command format>
or
(Response format)
When processing is performed normally
When processing is not performed normally
(Parameters explanation)
Unit No. Specifies the unit number to run a test with: 0 to the uppermost unit model number in the unit.
(Example)
The following sample command runs a test on unit number 5:
<Command>
<Response>
MOVSCENE or MSD
Copies the data for the scene with the number specified with command argument 1 to the scene with the
number specified with command argument 2. Deletes scene data with a number specified by command
argument 1 after completing copying. If there is already data at the copy destination, the copied data is
written over that data.
<Command format>
FZ4 User's Manual Controlling/Outputting through Serial Communication (Non-procedure)
7
489