Operational Flow; Error Messages - Omron F160 Operation Manual

Operational Flow

1-5 Operational Flow
Preparations
SeeAlso
Set Detection Conditions
CHECK
1,2,3...
SeeAlso
Confirm Settings and Execute Measurement
1,2,3...

Error Messages

Troubleshooting
Changing, Adding, and Deleting Settings
Saving Settings
Turn ON the power supply.
The inspection object will appear on the monitor.
Refer to page 12 for information on starting the F160 and displaying images.
To learn about the basic operational flow from setting inspection conditions to
measurement, refer to page 21.
1. Enter Set Mode. (Refer to Starting Conversational Menus on page 21.)
2. Register the reference image. (Refer to Registering Reference Images on
page 22.)
3. Set the detection conditions for presence inspection. (Refer to Selecting
and Setting Inspection Types on page 28.)
4. Compensate for workpiece position displacement. (Refer to Inconsistent
Workpiece Positions on page 31.)
5. Select the measurement method that suits the inspection target.
Refer to page 48 for information on conformity inspections.
Refer to page 50 for information on orientation inspections.
Refer to page 52 for information on position inspections.
Refer to page 57 for information on dimension inspections.
Refer to page 62 for information on chip and bur inspections.
Refer to page 63 for information on surface inspections.
1. Perform tests and make fine adjustments to measurement conditions. (Re-
fer to Entering Monitor Mode and Testing page 35.)
2. Start measurement. (Refer to Entering Run Mode and Starting Inspections
on page 43.)
When an error message has been displayed on the screen, refer to Trouble-
shooting on page 124.
If you think that there may be a malfunction, refer to FAQ on page 126 or refer
to the Setup Manual.
Change, add, or delete the inspection position referring to Changing and
Clearing Inspection Conditions on page 66.
• Save the inspection conditions. (Refer to Saving Settings and Exiting the
F160 on page 44.)
• Back up the image and system scene data. (Refer to Backing Up Data on
page 78.)
Section 1-5
9