Omron FZ4 Series User Manual page 564

Address setting
7
I/O setting
3.
Tap [OK].
The settings are confirmed and the Ethernet window closes.
562 Externally Outputting Data through FTP
Setting item
Obtain an IP address automatically
●
[Use the following IP address]
●
IP address
Subnet mask
Default gateway
DNS server
Input mode
Input format
Output IP address
I/O port No.
Setting
value
[Factory
default]
Set the IP address of the controller.
When "Obtain an IP address
automatically" is selected, the IP
address of the controller will be
automatically obtained.
When "Use the following IP address" is
selected, set the IP address, subnet
mask, and the default gateway address.
a.b.c.d
a: 1 to 223
b: 0 to 255
Input the controller IP address.
c: 0 to 255
d: 0 to 255
[10.5.5.100]
0.0.0.0 to
255.255.255.255 Input the subnet mask address.
[255.255.255.0]
0.0.0.1 to
255.255.255.254 Input the default gateway address.
[10.5.5.110]
a.b.c.d
a: 1 to 223
b: 0 to 255
Input the DNS server address.
c: 0 to 255
d: 0 to 255
[10.5.5.1]
[Normal] This item cannot be changed.
[ASCII] This item cannot be changed.
a.b.c.d
a: 1 to 223
b: 0 to 255
Input the output destination IP address.
c: 0 to 255
d: 0 to 255
[0.0.0.0]
Set the port No. to use for data I/O with
the controller. When PLC link or UDP
communication is used in addition to
FTP, specify the I/O port number to be
0 to 65535 used in each communication.
[9600] Set the same port number on the host
side and the FZ side.
FTP uses 20 and 21 for I/O ports
regardless of the I/O port number
settings.
Description
FZ4 User's Manual