Omron FZ4 Series User Manual page 552

Example) When 1 expressions are set in [Parallel Data Output]:
7
Reference
The output signal functions the same as when "Output Control" is set to "None".
●
Reference:
Input signal
Signal
DI0 to 6
DI7
Reference
The ERROR signal turns on when the input command is not correctly performed.
●
Acquisition is difficult since the amount of time during which the BUSY signal is turned OFF during a continuous
●
measurement by the parallel command is extremely short at 1 ms or less. Acquires the OR signal at the time
when the GATE signal turns ON after adding the parallel judgement output at the end of the flow.
550 Controlling/Outputting through Parallel Communication
When "Output Control" Is Set to "None" (p.547)
It turns off while continuously measuring (DI7 being turned on).
This is the execution trigger.
After DI0 to 6 is set, turn DI7 on after an interval over 1 ms.
Always have this turned ON during a continuous measurement. Stops continuous measurement
when this is turned OFF.
Function
FZ4 User's Manual