Omron FZ4 Series User Manual page 101

Setting
value
Setting item
[Factory
default]
[None]
Data
Only NG
Logging
All
6.
Set the logging data save destination.
Setting
value
Setting item
[Factory
default]
●
[RAMDisk]
Folder name
●
USBDisk
Important
If a USB memory or a network drive is specified as the save destination, the processing time may be
●
longer or fluctuate. Be sure to check it thoroughly before starting an operation.
When image logging or data logging is executed for a network drive, the communication may be
●
disrupted and the logging process may not be executed successfully due to the controller measurement
load that becomes too heavy when the multiple image input function is used. In this case, set a
reasonable amount of measurement takt time.
Reference
About loading data to a PC
Factory settings are set so that logging data is saved in the controller RAMDisk.
●
When logging data is loaded to a PC, set USBDisk as the save destination.
Logging data is first saved to the controller RAMDisk and then can be copied from the RAMDisk and
saved to the USBDisk using "Copy files" in "Save to file".
7.
Tap [OK].
Settings are confirmed and the Logging Setting window closes.
FZ4 User's Manual
Measurement data is not saved.
Measurement data is saved when an NG error occurs in a unit before
"Data Logging". If an NG error occurs after the "Data Logging"
processing unit, data logging is not performed.
All measurement data is saved.
The data is saved in the specified destination folder (RAMDisk or
USBDisk). Set the file name with the processing unit [Data Logging].
(Maximum number of characters: 128 single-byte characters)
Description
Description
Useful Functions for Operation
3
99