How to Start
1.
From the Start button located in the lower left area of the window of the remote operation PC,
select [Start] - [All Programs] - [OMRON] - [FZ4 Simulator] and then select and launch [FZ
Remote Operation Tool].
Note that a window that can be measured must be displayed on the controller.
Important
Do not connect or disconnect [FZ Remote Operation Tool] when a measurement is being performed or
●
the system is running.
2.
In the dialog box displayed by [FZ-RemoteOperator], select or directly enter the IP address and
the "Line No" of the controller to be connected. Press [Browse] to find the IP address and the line
number of the controller that can be connected.
* The "Line No" selected here is one of the following based on the system's operation mode.
High-speed logging mode
Parallel-operation high-speed mode
Single-line High-speed mode
Non-stop adjustment
Multi-line random trigger
The controller cannot be connected if a line number other than above is specified.
3.
As necessary, change the size of the image to transfer for the remote operation. Select (
set.
FZ4 User's Manual
Operation mode
Measurement
window
Non-stop adjustment
window
Line 0 side
Line 1 side
Remotely Operating the Controller (Remote Operation)
Setting
Line No = 0
Line No = 0
Line No = 0
Line No = 0
Line No = 1
Line No = 0
Line No = 1
4
) to
325