Table of Contents
Advertisement
Auto Load
Forms Set
Load
STOP
Figure 41. Forms Feed button
1
10. Raise the tension arm until you see the alignment mark in the guide notch.
Checking alignment of tractored forms
About this task
Do this procedure to check that the forms are aligned correctly on the tractor holes.
Procedure:
Procedure
1. Check the tractor holes on the forms between the transfer station and the fuser
Toner
Mark
Forms Feed
Forward
Reverse
7. Align the top of forms sensor with the appropriate size on the scale.
8. Ensure that the tension arm is aligned correctly. The mark on the tension arm
(1) should be visible in the notch in the transfer station frame.
9. Turn on the forms path vacuum by pressing the Vacuum Push Button. The
Vacuum-Off warning indicator flashes and then stays off.
entry area. If the holes show signs of tearing, adjust the Tractor Control Knob
as needed.
Chapter 5. Working with forms
85
Advertisement
Table of Contents
