Table of Contents
Advertisement
4. For the printer to operate, the line on the tension arm must be visible through
Tension Arm
Alignment
Mark and
Guide Notch
5. Close the center and top covers of the printer.
the guide notch. If it is not visible, do the following to move the tension arm to
the correct position:
Note: It is necessary to hold the tension arm down while you press the stacker
table UP switch or the Puller Run button.
Note: It is necessary to hold the tension arm down while you press the Puller
Run button.
Press the Puller Run button on the left side of the input area. This causes
a.
the puller rolls to run for five seconds.
b. Gently push the tension arm to the correct position.
c. When the line is visible in the guide notch, turn on the forms path vacuum
by pressing the forms path vacuum push button. The Vacuum-Off warning
indicator flashes and then stays off.
d. If the intervention panel is still displayed, press Check Reset on the
operator panel or the touch panel. If the message continues, contact your
service representative.
Chapter 5. Working with forms
149
Advertisement
Table of Contents
